Vibrating Feeder
Uniform, controlled feeding of rock into the crusher
« A crushing line begins with correct feeding »
Installation and commissioning nationwide by experienced engineers
What is a vibrating feeder & Imen Sang Shekan expertise
The vibrating feeder by Imen Sang Shekan provides uniform, controlled feeding of rock into jaw or impact crushers. Regular vibration prevents bulk stone dumping and sudden shock loads at the crusher mouth.
The body is built from wear-resistant steel plate and the drive can be an eccentric vibrator motor or contra-rotating eccentric shafts. Vibration amplitude is adjusted with counterweights to match material type and line capacity.
In a crushing line the feeder is what prevents both no-load running and overload. That simple control noticeably extends jaw plate and hammer life and optimises power consumption.
Most premature crusher failures trace back to irregular feeding; a correctly sized vibrating feeder is the cheapest insurance for your line.
Why the Imen Sang Shekan vibrating feeder?
- FeedSet™ amplitude tuning: feed rate is changed by adjusting counterweights — no part replacement needed.
- Optional grizzly section: separating soil and fines ahead of the crusher removes useless load from the line.
- Wear-resistant body: the pan is built from hardened plate with replaceable liners.
- Engineered springs and frame: springs sized for the real dynamic load extend frame and foundation life.
- Matched to your crusher: opening dimensions and discharge height are designed for your specific crusher.
- Simple installation: the portable skid suits mobile lines and quick relocation.
Applications & suitable projects
- Fixed crushing lines: feeding the primary jaw crusher from under the hopper
- Mobile plants: feeding jaw and impact crushers on a movable chassis
- Sand and gravel quarries: soil removal with a grizzly plus uniform feeding
- Asphalt plants: cold feeding of aggregate to the dryer
- Recycling units: controlled feeding of construction waste
If your crusher sometimes runs empty and sometimes jams, the problem is usually the feeder, not the crusher. Our engineers will size the right feeder for your line.
FeedSet™ technology — feeding matched to line capacity
FeedSet™ is a set of engineered adjustments that matches the feeder to the crusher's real capacity:
- Dynamic load calculation: springs, frame and foundation are sized from material weight and vibration amplitude.
- Slope angle setting: pan slope is chosen for material moisture and stickiness so flow stays uniform.
- Inverter speed control: feed rate can be raised or lowered from the control room in step with crusher load.
- Adjustable grizzly spacing: bar spacing is selected from feed gradation and soil content.
Result: higher real line throughput, fewer stoppages from crusher jamming, and lower wear-part consumption.
After-sales service & technical support
- Installation on foundation or mobile chassis with precise alignment to the crusher
- Amplitude and slope tuned to your material
- Operator training for feed-rate control and daily inspection
- Supply of springs, vibrator motors, bearings and liners with exact part numbers
- Periodic inspection for frame cracking and spring condition
- 24/7 technical support by phone, WhatsApp and on-site visits
- 6-month warranty and 10 years of after-sales service
Request a consultation to size the feeder for your crusher and feed gradation.
Photo Gallery
